Vehicles can be grouped into Types for tracking and management. The Vehicle Types tab allows customers to create and edit default settings assigned to each Type of Vehicle in the Fleet.
Newly added Vehicles will have those Vehicle and Alarm settings assigned to their corresponding Type until they are eventually edited.
Click the Add button if you want to add a new Vehicle Type or click on an existing one (underlined) to edit its information.
When the Vehicle Type dialog appears, under Vehicle Type:
Remember that, when adding or editing entries in Fleet Settings, required fields are always preceded by red asterisks.
IMPORTANT: Alarm Type Considerations
The number and type of Alarms available in the Vehicle Type and Vehicle menus can vary depending on the DVR installed in the Vehicle. In general terms, the Alarm types help organize alarms and other signals based on the response expected from the system after the event.
Some DVR models have a two-pin alarm input that allows the connection of an Alarm Switch (figure on the left showing a red button). During installation, alarms triggered by this button are configured as Alarm 0 in LIVE+. An Event-Diagnostic button (figure on the right with green ring light) can also be installed, unless the required harness connection is already being used by a RGY light indicator that displays DVR recording and video loss conditions. Alarms triggered by the Event-Diagnostic button are necessarily configured as Alarm 1.
Some recorders don’t have the input for the Alarm Switch, and these only allow the installation of the Event-Diagnostic button through the provided harness.
Both buttons can be pressed at the driver’s discretion after an event. By doing so, the DVR registers the exact moment of the event to facilitate later analysis.
The rest of the Alarm types in the menu are assigned to automatic vehicle event signals and configured as desired.
If selected, a video is automatically converted to .avi file and uploaded to the customer’s FTP site. By default, video starts 4 seconds before and ends 4 seconds after the event. Notice that only one Alarm Type can be set for FTP Upload.